Photos

Casting new methods of production saves Air Force time, money

A prototype TF33 rear gearbox housing sits on a table at Tinker Air Force Base, Oklahoma, Aug. 25, 2022. The prototype was manufactured in the same process as the original part, but the mold for its casting was additively manufactured, allowing parts to be created on demand. (U.S. Air Force photo by Paul Shirk)

PHOTO BY: Paul Shirk
VIRIN: 220825-F-HI919-1001.JPG
FULL SIZE: 4.2 MB
Additional Details

CAMERA

Canon EOS R5

LENS

EF24-105mm f/4L IS II USM

APERTURE

4

SHUTTERSPEED

1/125

ISO

800

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.

Go to Gallery