Metals Technology Airmen reduce two year wait time to two month
The Computer Numeric Control Machine (CNC) is performing calculated cuts on a large block of plastic material, July 6, 2021, at Mountain Home Air Force Base, Idaho. The plastic material is used as a prototype for the aluminum material. When it is loaded in the CNC with the right calculations, the aluminum material will be crafted into a trunnion beam. (U.S. Air Force photo by Senior Airman Akeem K. Campbell)
PHOTO BY:
Senior Airman Akeem K. Campbell
VIRIN:
210706-F-RA633-1056.JPG
FULL SIZE:
7.16 MB
CAMERA
NIKON D810
LENS
24.0-120.0 mm f/3.5-5.6
APERTURE
56/10
SHUTTERSPEED
1/250
ISO
800
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.